SOLDER TERMINAL PIN (TYPE 2)
By inserting pin up to its shoulder these pins stand at a fixed height above the board surface. The separated profile offers good mechanical retention while electrical contact is made by soldering shoulder to copper track. Available in two sizes for hole size 1,02and 1,32 mm.
Ordering information
Hole | A | B | C | D | E | Order |
1.00 mm | 9.7 | 5.6 | 1.1 | 1.0 | 0.4 | 18-0222 |
1.32mm | 11.9 | 6.7 | 1.4 | 1.2 | 0.5 | 18-0219 |
SOLDER TERMINAL PIN (TYPE 3)
Similar to 18-0222 but manufactured from phosphor bronze to BS 2873 PB 102, tin finish over copper flash.
Hole | Order |
1.0 mm | 18-0218 |
SOLDER TERMINAL HALF PIN (TYPE 4) 
These pins are ideally
suited to take off points or flying leads from a PCB. The shoulder is soldered to the copper track with the pin protruding on the component side of the board. Two sizes are available for 1,02 and 1,32 mm diameter holes.
Ordering information
Hole | Dim A | Order |
1.32 mm | 1.21mm | 18-0217 |
1.00mm | 0.93mm | 18-0223 |
Wirewrapping pins
SINGLE SIDED PIN (TYPE 10) 
For use with plain or copper-clad boards. These pins have the facility for soldering discrete components on one side and wire wrapping on the other.
Material: Manufactured from phosphor bronze to BS 2870 PB 102 with tin finish over copper flash.
Post size: 0,68 mm x 0,64 mm, diagonal 0,94 mm
Pierced | Drilled | Order |
1.00mm | 1.05mm | 18-0226 |
Supplied in packets of 500
DOUBLE SIDED PIN (TYPE 11)
For use when wire wrapping is required both sides of board.
Pierced | Drilled | Order |
1.00mm | 1.05mm | 18-1657 |
